Fibre optique

HSP Heat-shrink Splice Protectors - Fibre optique -  Electricité

HSP Heat-shrink Splice Protectors

 

After the fusion splicing it is necessary to restore the protection of the uncoated fiber.
The heat-shrink splice protector is the method employed most frequently to ensure dependable protection of a splice. After the protector is aligned over the splice point, it is applied using a heat-shrink oven. The heat-shrink splice protector lends the splice mechanical stability and protects it against environmental influences and possible damage during handling and splice storage.

 

Heat-shrink Splice Protectors for Single Fibers The heat-shrink splice protector for single fibers is used to protect single-fiber splices with coatings from 250μm to 900μm in diameter.


Ce produit vous intéresse ?
Contactez nous

Caractéristiques

 

• Length versions (standard): 40mm, 45mm, 60mm
• Available in other lengths upon request (25mm to 60mm in 5mm increments)
• Protects splices with coatings from 250μm to 900μm in diameter
• Protects splices with uncoated fiber length up to
40mm (60mm version)
• Fast and dependable heat-shrink process (depending on the heat-shrink oven type and its settings) for air-tight enclosure of the splice point
• Preshrunk ends for simple and error-free fiber handler
• Stainless steel with rounded ends to eliminate the risk of fiber damage
• Inner EVA tube made of transparent hot-melt adhesive and with an exceptionally smooth inside wall
• Exterior heat-shrink tube, transparent, for easy alignment over the splice point
• Upon request, also available with colored ID stripes (e.g., in Telecordia color scheme)